Installing and Removing a Half-Height Bay Device 10-9
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 6:40 PM
Part Number: 203118-001 File name: Ch10.doc
2. Remove the four screws from the drive.
Removing the Screws from the Half-Height Drive
3. Place the drive cage over the half-height drive.
4. Attach the drive cage to the half-height drive by loosely
replacing the four screws that you removed from the half-
height drive. Insert the screws through the drive cage and into
the half-height drive.
NOTE:
Two sets of screw holes are provided on each side of the
drive cage. Select the pairs of holes that match the holes in the
sides of the half-height drive.
Attaching the Drive Cage to the Half-Height Drive
To Next Page
Loading...
