Installing and Removing a Half-Height Bay Device 10-11
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 6:40 PM
Part Number: 203118-001 File name: Ch10.doc
Inserting the Drive Cage Assembly into the Desktop
Expansion Base
To insert the drive cage assembly (the drive cage attached to the
half-height drive) into the expansion base, follow these steps:
1. Attach the cables on the back of the half-height drive to the
connectors on the expansion base. For connection information,
refer to the half-height drive documentation.
2. Align the holes in the front and rear base tabs of the drive cage
with the pins on the bottom of the expansion base.
3. Place the aligned drive cage assembly on the bottom of the
expansion base.
Placing the Drive Cage Assembly onto the Bottom of the Desktop Expansion Base
To Next Page
Loading...
