10-12 Installing and Removing a Half-Height Bay Device
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 6:40 PM
Part Number: 203118-001 File name: Ch10.doc
4. Connect the half-height drive power cable included with the
expansion base and any other cables required by the drive as
directed in the documentation that came with the drive.
5. Tuck the cables attaching the drive cage assembly to the
expansion base beneath the slots that will be used to reconnect
the metal drive cage shield to the metal plate
Tucking Cables Beneath the Drive Cage Shield Slots
6. Replace the drive cage shield by inserting the four tabs along
the back of the drive cage shield into the four slots on the
metal plate. (Be sure no cables are caught between the drive
cage shield and the metal plate.)
To Next Page
Loading...
