Figure 6-2 Removing the Top Cover
Replacing the Top Cover
To replace the top cover, follow these steps:
1. Ensure the cover release lever is in the open position.
2. Align the tabs of the top cover with the corresponding slots in the server and insert the tabs
into the slots (1).
3. Slide the cover forward until it is flush with the front of the server (2).
4. Push the cover release lever down into the latched position (3).
5. Lock the cover release lever (if required) by turning the cam approximately 90 degrees
clockwise (4).
6. Replace the allen wrench on the rear panel of the server.
144 Removing and Replacing Server Components
To Next Page
Loading...
