NOTE: Due to the type of server you purchased, your output may not exactly match the
output shown here.
Shell> map
Device mapping table
fs0 : Acpi(000222F0,269)/Pci(0|0)/Scsi(Pun8,Lun0)/HD(Part1,Sig72550000)
blk0 : Acpi(000222F0,269)/Pci(0|0)/Scsi(Pun8,Lun0)
blk1 : Acpi(000222F0,269)/Pci(0|0)/Scsi(Pun8,Lun0)/HD(Part1,Sig72550000)
blk2 : Acpi(000222F0,269)/Pci(0|0)/Scsi(Pun8,Lun0)/HD(Part2,Sig72550000)
blk3 : Acpi(000222F0,2A8)/Pci(0|0)/Scsi(Pun8,Lun0)
blk4 : Acpi(000222F0,2A8)/Pci(0|1)/Scsi(Pun2,Lun0)
Shell> fs0:
fs0:\> hpux
(c) Copyright 1990-2002, Hewlett Packard Company.
All rights reserved
HP-UX Boot Loader for IA64 Revision 1.723
Press Any Key to interrupt Autoboot
\efi\hpux\AUTO ==> boot vmunix
Seconds left till autoboot - 9
5. Exit the server console and iLO 2 MP interfaces when finished.
• To exit the server console and return to the iLO 2 MP Main Menu, enter Ctrl-B.
• To exit the iLO 2 MP, enter X at the iLO 2 MP Main Menu.
Booting HP-UX in Single-User Mode
From the EFI Shell environment, boot in single-user mode by stopping the boot process at the
HPUX.EFI interface (the HP-UX Boot Loader prompt, HPUX>) and entering the boot -is
vmunix command.
To boot HP-UX in single-user mode, follow these steps:
1. Access the EFI Shell environment for the system on which you want to boot HP-UX in
single-user mode.
Log in to the iLO 2 MP and enter CO to choose the server console.
When accessing the console, confirm that you are at the EFI Boot Manager Menu. If you
are at another EFI menu, choose the Exit option from the submenus until you return to the
screen with the EFI Boot Manager heading.
From the EFI Boot Manager menu, choose the EFI Shell menu option to access the EFI Shell
environment.
2. Access the EFI System Partition (fsX: where X is the file system number) for the device
from which you want to boot HP-UX.
3. When accessing the EFI System Partition for the desired boot device, issue the HPUX command
to initiate the \EFI\HPUX\HPUX.EFI loader on the device you are accessing.
4. Boot to the HP-UX Boot Loader HPUX> prompt by pressing any key within the 10 seconds
given for interrupting the HP-UX boot process. Use the HPUX.EFI loader to boot HP-UX
in single-user mode in the next step.
After you press a key, the HPUX.EFI interface (the HP-UX Boot Loader HPUX> prompt),
launches. For help using the HPUX.EFI loader, enter the help command. To return to the
EFI Shell, enter exit.
fs0:\> hpux
(c) Copyright 1990-2002, Hewlett Packard Company.
All rights reserved
Booting and Shutting Down HP-UX 91
To Next Page
Loading...
Need help?
General