(1) ADD an entry to the Boot Options list
(2) DISPLAY the Boot Options list
(3) REMOVE an entry from the Boot Options list
(4) MOVE the position of an entry in the Boot Options list
(5) VALIDATE boot options and fix them as necessary
(6) Modify Boot Options TIMEOUT setting
(B) Set to operate on the Boot Device Options list
(D) Set to operate on the Dump Device Options list
(G) Set to operate on the Debug Device Options list
(E) EXIT from Boot Manager utility
You can also enter Ctrl-Y at any time to abort this utility.
Enter your choice:
To ADD an entry to the Boot Options list, select option (1):
Enter your choice: 1
Enter the device name (Enter "?" for a list of devices): ?
Device Device Error Volume Free Trans Mnt
Name Status Count Label Blocks Count Cnt
$1$DGA700: (NODE1) Mounted 0 (remote mount) 1
$1$DGA1510: (NODE1) Mounted 0 (remote mount) 1
$1$DGA4000: (NODE1) Mounted 0 WORK 130695025 1 9
$26$DKB5: (NODE1) Mounted 0 DISK_V83 540949440 333 1
Device Device Error
Name Status Count
EWA0: Online 1
EWB0: Online 0
EFI Built-in EFI Shell
Enter the device name (Enter "?" for a list of devices): $26$DKB5
Enter the desired position number (1,2,3,,,) of the entry.
To display the Boot Options list, enter "?" and press Return.
Position [1]: 10
Enter the value for VMS_FLAGS in the form n,n.
VMS_FLAGS [NONE]:
Enter a short description (do not include quotation marks).
Description ["$26$DKB5"]: V83 System Disk
efi$bcfg: $26$dkb5 (Boot0008) Option successfully added
Enter your choice:
NOTE: Due to the type of server you purchased, your output may not exactly match the output
shown here.
For more details, see HP OpenVMS Version 8.3 for Integrity Servers Upgrade and Installation
Manual.
Booting OpenVMS
To boot OpenVMS on an rx2660, use either of the following procedures:
• “Booting OpenVMS (EFI Boot Manager)” (page 95)
• “Booting HP OpenVMS (EFI Shell)” (page 95)
94 Booting and Shutting Down the Operating System
To Next Page
Loading...
Need help?
General