HP Integrity rx2660

standby state, defined, 78
states, 65, 78
power button, 84
function, 28
LED, 29
power problems, 84
power reset command (see PR)
power subsystem (see power)
power supply
LEDs, 34
load order, 47, 153
removing, 153
replacing, 154
Power Supply, Hot-Swap, 47
Replace, 48
powering off the server, 79
manually, 79
using the iLO 2 MP PC command, 79
powering on the server, 78–79
manually, 79
using the iLO 2 MP PC command, 79
PR command, 78
Pre-OS System Environment (see EFI/POSSE)
Pre-OS System Startup Environment (see POSSE)
processor
configuration options, 52, 175
installing, 52, 180
introduction, 23
load order, 53, 176
removing, 176
required service tools, 53, 176
restrictions, 53, 176
Processor Abstraction Layer (see PAL)
R
Rack
Installing Into, 64
rack
anti-tip features, 142
extending the server from, 142
extension clearance, 142
inserting the server into, 143, 209
rack-mount server
accessing, 142
rackless (see tower-mount)
rear panel
functional overview, 31
Remove and Replace
Hard Drive, Hot-Plug, 45
PCI-X/PCIe Cards, 35
PCI/PCI-X Cards, 58
Power Supply, Hot-Swap, 47
reset button
MP, 33
S
safety information, 204
safety information, general, 42, 140
SAL
defined, 26
SAS
features and capabilities, 193
technology overview, 193
SAS backplane
removing, 194
replacing, 195
SAS I/O card
removing, 188
replacing, 191
SCSI
setup utility, 233
specifying parameters, 233
SCSI adapter
path, 234
security risk with DHCP enabled, 76
serial-attached SCSI (see SAS)
server
installation checklist, 43
server backup, 205
service tools, 140
shut down
HP-UX, 93
Linux, 104
Windows, 100
from command line, 100
static IP address
assigning with ARP Ping, 72
assigning with LC command, 73
storage (see mass storage)
supported operating systems, 87
System Abstraction Layer (see SAL)
system battery
recording configuration settings before removing, 185,
196
removing, 185
replacing, 186
reset system settings after replacing, 186
system block diagram, 20
system board
ports, described, 33
system configuration menu, 242
system fans (see fans)
system health
LED, 28
System Insight Display
introduction, 29
LEDs, 29
system LAN
link speed LEDs, 34
link status LEDs, 34
ports, 34
T
top cover (see cover, top)
tower-mount server
accessing, 143
troubleshooting
console problems occur, 86
248 Index