HP integrity rx2800 i4 User Manual

A Utilities
SAS disk setup
Using the saupdate command
The saupdate command is used to query or change the mode of the Smart Array P410i and
Smart Array P411 controllers to HBA or RAID. Querying or changing modes is not supported for
other controllers.
The newly added commands to SAUPDATE are:
• Get Mode
• Set Mode
Get mode
This command displays the current mode of the controllers.
Syntax
saupdate get_mode <controller>
<controller> can be any one of the following strings.
Table 44 <controller> strings
Meaning<controller>
A controller having the PCI segment id, bus id, device id and function id is addressed<seg:bus:dev:func>
Addresses all controllers in the systemall
Controllers of a particular type indicated by the <model> string are addressed<model>
Figure 40 saupupdate get_mode
Set mode
IMPORTANT: If you are using HBA mode, do not install any disk that has previously been a part
of a RAID volume into the system.
Set mode is used to change the mode of the controller. If the controller is already in the required
mode the following message appears:
The controller at seg:bus:dev:funcis already in HBA|RAID mode.
HP Confidential SAS disk setup 137

HP integrity rx2800 i4 Specifications

General

Number of Processors	1 or 2
Memory Slots	24 DIMM slots
Processor Cores	4 or 8 per processor
Cache	32 MB L3 per processor
Memory	Up to 384 GB DDR3
Storage	Up to 8 SFF SAS/SATA drives
RAID Support	RAID 0, 1, 5, 6
Network	Integrated 10/100/1000Base-T Ethernet
Network Controller	HP NC382i
Expansion Slots	6 PCIe 2.0 slots
Power Supply	Hot-plug redundant power supplies
Operating Systems	HP-UX, Linux
Form Factor	2U Rack
Processor Speed	1.73 GHz, 2.13 GHz, or 2.53 GHz