HP integrity rx2800 i4 - Verifying Installed Components in the Server

Verifying installed components in the server
Use the following procedure to verify that the components you have installed into the server are
recognized by the server:
1. Press S to enter the UEFI shell.
2. Wait for the UEFI Shell prompt to appear.
3. Enter info all from the UEFI Shell prompt. The following appears:
NOTE: Your display might not match the display shown.
info all
SYSTEM INFORMATION
[Details omitted]
CPU INFORMATION
[Details omitted]
BOOT PROCESSOR INFORMATION
[Details omitted]
MEMORY INFORMATION
[Details omitted]
I/O INFORMATION
[Details omitted]
PCI DEVICE INFORMATION
[Details omitted]
CONSOLE CONFIGURATION
[Details omitted]
BOOT INFORMATION
[Details omitted]
FIRMWARE INFORMATION
[Details omitted]
SYSTEM SECURITY CONFIGURATION
[Details omitted]
Shell>
HP Confidential Verifying installed components in the server 57