HP integrity rx2800 i4 User Manual

Figure 10 Attaching the bezel cover
Attaching the pedestal kit side pieces
The pedestal kit right side piece attaches to the top of the server. The top cover of the server might
have ventilation holes in it to enable proper air flow and cooling. The right side piece of the
pedestal kit also has ventilation holes in it to enable the proper cooling and air flow. Follow these
steps to attach the pedestal kit right side piece.
WARNING! The ventilation holes in the pedestal kit right side piece must be matched up with
the ventilation holes on the top cover of the HP Integrity rx2800 i4 Server to enable proper cooling
and air flow. Failure to heed this warning causes the server to shut down with an overtemp condition.
To attach the component:
1. Align the posts on the pedestal kit right side piece with the slots in the pedestal kit top and
bottom.
2. Hold the pedestal side flush against the server and slide it toward the front of the server.
HP Confidential Installing the server into a rack or pedestal 23

HP integrity rx2800 i4 Specifications

General

Number of Processors	1 or 2
Memory Slots	24 DIMM slots
Processor Cores	4 or 8 per processor
Cache	32 MB L3 per processor
Memory	Up to 384 GB DDR3
Storage	Up to 8 SFF SAS/SATA drives
RAID Support	RAID 0, 1, 5, 6
Network	Integrated 10/100/1000Base-T Ethernet
Network Controller	HP NC382i
Expansion Slots	6 PCIe 2.0 slots
Power Supply	Hot-plug redundant power supplies
Operating Systems	HP-UX, Linux
Form Factor	2U Rack
Processor Speed	1.73 GHz, 2.13 GHz, or 2.53 GHz