Setup checklist
Use the checklist in Table 8 while setting up the Integrity iLO 3.
Table 8 Setup checklist
StatusProcedureActionStep
Standard setup
Preparation1 1. Determine an access method to select and connect the
cables.
2. Determine a LAN configuration method and assign an IP
address if necessary.
Select one of the three methods to configure the LAN for iLO
3 MP access:
Configure the iLO 3 MP LAN2
• DHCP with DNS
• RS-232 serial port
• Static IP address
Log on to the iLO 3 MP from a supported web browser or
command line using the default user name and password.
Log on to the iLO 3 MP3
Change the default user name and password on the
administrator account to your predefined selections.
Change default user name and
password
4
Set up the user accounts if you are using the local accounts
feature.
Set up user accounts5
Set up the security access settings.Set up security access6
Accessing UEFI or the OS from iLO MP
The Unified Extensible Firmware Interface is an architecture that provides an interface between the
server OS and the server firmware. UEFI provides a standard environment for booting an OS and
running preboot applications.
Use this procedure to access UEFI or the OS from the iLO MP. Your security parameters were set
regarding remote access.
NOTE: Commands are case-insensitive.
1. From the MP Main Menu, enter the commandco to access the Console.
NOTE: Terminal windows must be set to a window size of 80 columns x 25 rows for optimal
viewing of the console at UEFI.
2. After memory test and CPU late self test the following message appears:
Press Ctrl-C now to bypass loading option ROM UEFI drivers.
The prompt times out if Ctrl-C is not pressed within a few seconds. If Ctrl-C is pressed, you are
presented with two options:
• Bypass loading from I/O slots.
• Bypass loading from I/O slots and core I/O.
The Bypass loading from I/O slots and core I/O option may be useful if a bad core I/O
UEFI driver is preventing system boot. USB drives can still be used at the UEFI shell to
update core I/O drivers.
CAUTION: Pressing Ctrl-C before the prompt does not work and might disable this
feature. Therefore, be sure to wait for the prompt before pressing Ctrl-C.
HP Confidential Accessing UEFI or the OS from iLO MP 27
To Next Page
Loading...
Need help?
General
