4. Locate the device you want to boot from.
a. For DVD, locate the device:
fs2:\> map
Device mapping table
fs6: Removable CDRom - Alias cd66d0a blk6
PcieRoot(0x30304352)/Pci(0x1D,0x7)/USB(0x3,0x0)/CDROM(0x0)
i. To list all the device names from the UEFI Shell prompt, use the map command.
ii. From the list generated by the map command, locate the device name (in this example,
fs6).
NOTE: Your DVD drive might not be named fs6. Make sure you verify the ID
appropriate to your DVD device.
Tape will autoboot without the need to select a boot image.
iii. At the UEFI Shell prompt, specify the device name for the DVD-ROM.
iv. Enter the appropriate UEFI install command, as in the following example:
HP-UX
Shell> fs6:
fs6:\> install
b. For tape, locate the device:
• To boot from tape once you are at the UEFI shell:
Shell> tapeboot select
01
PcieRoot(0x30304352)/Pci(0x8,0x0)/Pci(0x0,0x0)/SAS(0x50060B00007F6FFC,0x0,0x1,NoTopology,0,0,0,0x0)
Select Desired Tape: 01 <<input 01
◦ If the correct media is installed, it will boot from tape when you enter the index
number.
◦ If there is no media in the SAS tape drive and you select 1, you will see the
following message:
tapeboot: Could not load tapeboot image
The operating system will start loading onto the server.
5. Follow the on-screen instructions to install the OS fully.
6. Continue with “Configuring system boot options” (page 36)
Installing the operating system using HP Ignite-UX
Ignite-UX is an HP-UX administration toolset that enables:
• Simultaneous installation of HP-UX on multiple clients
• The creation and use of custom installations
• The creation of recovery media
• The remote recovery of clients
To install the OS onto the server using Ignite-UX, go to http://www.hp.com/go/ignite-ux.
Installing the operating system with Virtual Media
NOTE: Installing the OS with Virtual Media (vMedia) might be significantly slower than installing
using other methods.
HP Confidential Installing the operating system with Virtual Media 35
To Next Page
Loading...
Need help?
General
