HP integrity rx2800 i4 User Manual

Syntax
saupdate set mode <controller> <hba | raid> [-f]
<controller> can be any one of the strings listed in Table 44 (page 137).
An alert message about the possible data loss is displayed when a mode change command is
issued. A confirmation is required before the actual mode change is made. This ensures unintentional
change of mode does not happen.
Figure 41 Controller mode change alert message
The -f option indicates the user is aware of the changes that are being made and does not require
a warning message or a confirmation regarding the mode change.
Figure 42 saupdate set_mode
IMPORTANT: After changing the mode, perform a reconnect -r command at UEFI.
NOTE: Commands are not case-sensitive.
Updating the firmware using saupdate
1. Download the firmware image file into the system UEFI partition.
2. Boot the system to the UEFI Shell and change directories to the UEFI partition.
3. Use the saupdate list to display all detected Smart Array controllers along with the active
firmware versions, the identification information from this list is used to designate which
controller is to be updated.
4. Use saupdate update <seg:bus:dev:func:index> <firmware image> to update
the firmware.
5. Restart the system.
HP Confidential138 Utilities

HP integrity rx2800 i4 Specifications

General

Number of Processors	1 or 2
Memory Slots	24 DIMM slots
Processor Cores	4 or 8 per processor
Cache	32 MB L3 per processor
Memory	Up to 384 GB DDR3
Storage	Up to 8 SFF SAS/SATA drives
RAID Support	RAID 0, 1, 5, 6
Network	Integrated 10/100/1000Base-T Ethernet
Network Controller	HP NC382i
Expansion Slots	6 PCIe 2.0 slots
Power Supply	Hot-plug redundant power supplies
Operating Systems	HP-UX, Linux
Form Factor	2U Rack
Processor Speed	1.73 GHz, 2.13 GHz, or 2.53 GHz