HP integrity rx2800 i4 User Manual

Table 40 CRU list (continued)
Spare part numberDescription
456096–001SPS-SFP+,10G BLc,SR
319603-001System battery (CR2032)
1
Must be replaced together with a new processor.
CAUTION: FRU components are not customer-serviceable. You must contact an HP authorized
service provider to install or replace these components.
Table 41 FRU list
Spare part numberDescription
Boards
505836-001HP Integrity TPM Security Chip
Required tools
• T-10/T-15 wrench (attached to the outside of the server)
Safety considerations
Before performing service procedures, review all the safety information.
Server warnings and cautions
Before installing a server, be sure that you understand the following warnings and cautions.
WARNING! To reduce the risk of electric shock or damage to the equipment:
• Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
• Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all
times.
• Unplug the power cord from the power supply to disconnect power to the equipment.
• Do not route the power cord where it can be walked on or pinched by items placed against
it. Pay particular attention to the plug, electrical outlet, and the point where the cord extends
from the server.
WARNING! To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: Do not operate the server for long periods with the access panel open or removed.
Operating the server in this manner results in improper airflow and improper cooling that can lead
to thermal damage.
Preparation procedures
To access some components and perform certain service procedures, you must perform one or
more of the following procedures:
• Extend the server from the rack (“Extending the server from the rack” (page 95)).
If you are performing service procedures in an HP, Compaq branded, Telco, or third-party
rack cabinet, you can use the locking feature of the rack rails to support the server and gain
access to internal components.
HP Confidential94 Removal and replacement procedures

HP integrity rx2800 i4 Specifications

General

Number of Processors	1 or 2
Memory Slots	24 DIMM slots
Processor Cores	4 or 8 per processor
Cache	32 MB L3 per processor
Memory	Up to 384 GB DDR3
Storage	Up to 8 SFF SAS/SATA drives
RAID Support	RAID 0, 1, 5, 6
Network	Integrated 10/100/1000Base-T Ethernet
Network Controller	HP NC382i
Expansion Slots	6 PCIe 2.0 slots
Power Supply	Hot-plug redundant power supplies
Operating Systems	HP-UX, Linux
Form Factor	2U Rack
Processor Speed	1.73 GHz, 2.13 GHz, or 2.53 GHz