HP integrity rx2800 i4 User Manual

Table 4 System power specifications (continued)
Parameter
+12VSB /2.5A MAX+12VSB /2.5A MAX+12VSB /2.5A MAX
If an overload triggers the power supply overload protection, the system is immediately powered
off. To reset the power supply unit:
1. Disconnect the power cord.
2. Determine what caused the overload by contacting an HP support representative.
3. Reconnect the power cord.
4. Reboot the system.
NOTE: If an overload occurs twice, an undetected short circuit exists.
When you use the front panel power button to turn off the server, power consumption falls below
the low power consumption, but does not reach zero. To reach zero power consumption in "off"
mode, disconnect all power supplies from their power sources.
Power consumption and cooling
The power consumptions listed in Table 5 (page 15) are valid for the configuration shown. Please
use the HP Power Advisor tool to obtain power information for other configurations or utilization
factors.
Table 5 Standard configuration power consumption
Power consumptionStandard configuration
1228 Btu/h (maximum)360 W (maximum)One 1.46 GHz quad-core processor, 4 GB memory,
one 1200 W power supply, and one SAS disk drive
HP Confidential Server electrical specifications 15

HP integrity rx2800 i4 Specifications

General

Number of Processors	1 or 2
Memory Slots	24 DIMM slots
Processor Cores	4 or 8 per processor
Cache	32 MB L3 per processor
Memory	Up to 384 GB DDR3
Storage	Up to 8 SFF SAS/SATA drives
RAID Support	RAID 0, 1, 5, 6
Network	Integrated 10/100/1000Base-T Ethernet
Network Controller	HP NC382i
Expansion Slots	6 PCIe 2.0 slots
Power Supply	Hot-plug redundant power supplies
Operating Systems	HP-UX, Linux
Form Factor	2U Rack
Processor Speed	1.73 GHz, 2.13 GHz, or 2.53 GHz