HP Integrity Superdome 2 16-socket - ICAPMODIFY

ICAPMODIFY
• Command:
ICAPMODIFY
• Description:
Allows setting some configuration options, including notification email address and iCAP
system ID.
◦
◦ Allows activation and deactivation of cores in an nPar, or assignment and deassignment
of cores in a vPar.
◦ Defers activation/deactivation of cores in an nPar.
◦ Provides a mechanism for applying iCAP codewords to securely affect the complex iCAP
contract terms.
The options for the command:
MeaningLong optionOption
Activate <n> cores in nPar specified
by -p and -v
--activate n-a n
Specify the nPar and vPar ID,
separated by “:”. Each ID may be
--partition n[:v]-p n[:v]
either a number or a name. When
invoked through IPMI from an OS,
defaults to the originating partition.
Set the number of active cores in
partition to n; activate or deactivate
as necessary.
--set-active n-s n
Deactivate n cores in p/v--deactivate n-d n
Instead of immediately initiating an
OLA/D operation for -a/-d/-s,
--defer-D
modify the partition IA to take effect
on the next OS boot.
Apply a codeword to the complex.--codeword c-C c
Set contact email address, mostly
for use by GiCAP.
--contact c-c c
Set from-email address. A single
complex-wide from-address will be
supported.
--from-email-f f
Set iCAP system identification.
NOTE: May differ from complex
name.
--system-identifier i-i i
Warning period for temporary
capacity expiration.
--warning w-w w
Reconcile the number of active
cores in the partition to the parspec
IA.
--reconcile-r [system_startup]
Pre-authorize Ticap. If on is used,
all further activations are now
-T on|off
implicitly authorized to use TiCAP
if required. Off ceases the
pre-authorization.
126 iCAP commands