HP Integrity Superdome 2 16-socket - Show Interconnect Sessions; Show User Sessions

• Access level/Bay level:
All◦
◦ Bay specific
• Restrictions:
Dependent on bay privileges
• Example:
OA-0016355E560A> SHOW DEVICE SERIAL_NUMBER BLADE
Serial number: USM81500RP
SHOW INTERCONNECT SESSIONS
• Command:
SHOW INTERCONNECT SESSIONS
• Description:
Displays which users have serial console sessions in progress for each interconnect
• Access level/Bay level:
OA Administrator, OA Operator◦
◦ Bay specific
• Restrictions:
You must have access to the specified bay.
• Example:
OA-0018FE27577F> SHOW INTERCONNECT SESSION
Interconnect Bay User
------------------ --------------
No Interconnect remote console sessions were detected.
SHOW USER SESSIONS
IMPORTANT: On Superdome 2 systems, the following long-running commands are not immediately
subject to the session timeout defined by the SET SESSION TIMEOUT command:
• SHOW {HR | FPL | LIVELOGS | SEL | SYSLOG | PARTITION CONSOLELOG}
• CONNECT {BLADE | INTERCONNECT | PARTITION }
• CO
• FPL
• SEL
If a user has one of these commands active, their session will not be removed when a session
timeout occurs; instead it will be removed once they exit the long-running command and interact
with the CLI. The SHOW USER SESSIONS command will not display the active session after a
session timeout occurs.
• Command:
SHOW USER SESSIONS
• Description:
Displays a list of authenticated sessions on the OA, including CLI and WebGUI sessions.
SHOW INTERCONNECT SESSIONS 49