HP Integrity Superdome 2 16-socket - Set Session Timeout; Set User Access; Set User Contact

SET SESSION TIMEOUT
IMPORTANT: On Superdome 2 systems, the following long-running commands are not immediately
subject to the session timeout defined by the SET SESSION TIMEOUT command:
• SHOW {HR | FPL | LIVELOGS | SEL | SYSLOG | PARTITION CONSOLELOG}
• CONNECT {BLADE | INTERCONNECT | PARTITION }
• CO
• FPL
• SEL
If a user has one of these commands active, their session will not be removed when a session
timeout occurs; instead it will be removed once they exit the long-running command and interact
with the CLI. Furthermore, the SHOW USER SESSIONS command will not display the active session
after a session timeout occurs.
• Command:
SET SESSION TIMEOUT <timeout>
• Description:
Sets the number of minutes before inactive sessions are removed. The default setting is 1440.
The session timeout can be disabled by setting the timeout value to zero.
NOTE: If the session timeout value is lowered, currently inactive sessions may be removed.
• Access level/ Bay level:
OA Administrator
• Restriction:
Valid session timeout values range from 10 to 1440 minutes (24 hours).
SET USER ACCESS
• Command:
SET USER ACCESS "<user name>" {ADMINISTRATOR | OPERATOR | USER}
• Description:
Sets the user access level. Additionally, use the ASSIGN command to give the user access
rights to the Onboard Administrator, server bays, and interconnect bays.
• Access level/Bay level:
OA Administrator
• Restrictions:
None
SET USER CONTACT
• Command:
SET USER CONTACT ["<user name>"] "<contact info>"
• Description:
Sets the contact information field for the user. If there is no <user name>, the command
modifies the contact information of the user who executed the command.
26 User account commands