HP MSR2003 User Manual

103
Configuring BIDIR-PIM
This section describes how to configure BIDIR-PIM.
BIDIR-PIM configuration task list
Task at a
g
lance
(Required.) Enabling BIDIR-PIM
(Required.) Configuring an RP:
• Configuring a static RP
• Configuring a C-RP
• (Optional.) Configuring the maximum number of BIDIR-PIM RPs
NOTE:
You must configure a static RP, a C-RP, or both in a BIDIR-PIM domain.
In a network without C-RPs, skip the task of configuring a BSR.
Configuring a BSR:
• (Required.) Configuring a C-BSR
• (Optional.) Configuring a PIM domain border
• (Optional.) Disabling the BSM semantic fragmentation function
(Optional.) Configuring common PIM features
Configuration prerequisites
Before you configure BIDIR-PIM, configure a unicast routing protocol so that all devices in the domain are
interoperable at the network layer.
Enabling BIDIR-PIM
Because BIDIR-PIM is implemented on the basis of PIM-SM, you must enable PIM-SM before you enable
BIDIR-PIM. When you deploy a BIDIR-PIM domain, HP recommends that you enable PIM-SM on all
non-border interfaces of the domain.
IMPORTANT:
A
ll interfaces on a device must be enabled with the same PIM mode.
To enable BIDIR-PIM:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IP multicast
routing and enter MRIB
view.
multicast routing [ vpn-instance
vpn-instance-name ]
By default, IP multicast routing is
disabled.
3. Return to system view.
quit N/A
4. Enter interface view.
interface interface-type
interface-number
N/A

HP MSR2003 Specifications

General

Brand	HP
Model	MSR2003
Category	Network Router
Language	English