HP MSR2003 User Manual

113
Configuring common PIM timers globally
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter PIM view.
pim [ vpn-instance
vpn-instance-name ]
N/A
3. Set the interval for sending
hello messages.
timer hello interval The default setting is 30 seconds.
4. Set the interval for sending
join/prune messages.
timer join-prune interval
The default setting is 60 seconds.
NOTE:
This configuration takes effect after
the current interval ends.
5. Set the joined/pruned state
holdtime timer.
holdtime join-prune time The default setting is 210 seconds.
6. Set the multicast source
lifetime.
source-lifetime time The default setting is 210 seconds.
Configuring common PIM timers on an interface
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Set the interval for sending
hello messages.
pim timer hello interval The default setting is 30 seconds.
4. Set the maximum delay for
sending a hello message.
pim triggered-hello-delay delay The default setting is 5 seconds.
5. Set the interval for sending
join/prune messages.
pim timer join-prune interval
The default setting is 60 seconds.
NOTE:
This configuration takes effect after
the current interval ends.
6. Set the joined/pruned state
holdtime timer.
pim holdtime join-prune time The default setting is 210 seconds.
Setting the maximum size of each join or prune message
The loss of an oversized join or prune message might result in loss of massive information. You can set a
small value for the size of each join or prune message to reduce the impact.
To set the maximum size of each join or prune message:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter PIM view.
pim [ vpn-instance
vpn-instance-name ]
N/A

HP MSR2003 Specifications

General

Brand	HP
Model	MSR2003
Category	Network Router
Language	English