HP MSR2003 User Manual

225
Setting the aging timers for dynamic ports globally
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MLD-snooping view.
mld-snooping N/A
3. Set the aging timer for dynamic
router ports globally.
router-aging-time interval The default setting is 260 seconds.
4. Set the aging timer for dynamic
member ports globally.
host-aging-time interval The default setting is 260 seconds.
Setting the aging timers for the dynamic ports in a VLAN
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VLAN view.
vlan vlan-id N/A
3. Set the aging timer for the
dynamic router ports in the
VLAN.
mld-snooping router-aging-time
interval
The default setting is 260 seconds.
4. Set the aging timer for the
dynamic member ports in
the VLAN.
mld-snooping host-aging-time
interval
The default setting is 260 seconds.
Configuring static ports
You can configure a port as a static port for the following purposes:
• To make all the hosts attached to the port receive IPv6 multicast data for an IPv6 multicast group,
configure the port as a static member port for the group.
• To make the Layer 2 device attached to the port forward all received IPv6 multicast traffic on the port,
configure the port as a static router port.
When you configure static ports, follow these guidelines:
• A static member port does not respond to queries from the MLD querier. When you configure a port
as a static member port or cancel this configuration on the port, the port does not send unsolicited
MLD reports or MLD done messages.
• Static member ports and static router ports never age out. To remove such a port, use the undo
mld-snooping static-group or undo mld-snooping static-router-port command.
Configuration procedure
To configure static ports:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet interface
view.
interface interface-type
interface-number
N/A
3. Configure the port as a static
member port.
mld-snooping static-group
ipv6-group-address [ source-ip
ipv6-source-address ] vlan vlan-id
By default, a port is not a static
member port.

HP MSR2003 Specifications

General

Brand	HP
Model	MSR2003
Category	Network Router
Language	English