EasyManuals Logo

HP MSR2003 User Manual

HP MSR2003
350 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
75
[RouterA-GigabitEthernet2/1/1] quit
# Enable IP multicast routing on Router B.
<RouterB> system-view
[RouterB] multicast routing
[RouterB-mrib] quit
# Enable IGMP proxying on GigabitEthernet 2/1/1.
[RouterB] interface gigabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] igmp proxy enable
[RouterB-GigabitEthernet2/1/1] quit
# Enable IGMP on GigabitEthernet 2/1/2.
[RouterB] interface gigabitethernet 2/1/2
[RouterB-GigabitEthernet2/1/2] igmp enable
[RouterB-GigabitEthernet2/1/2] quit
Verify the configuration
# Display the multicast group membership information maintained by the IGMP proxy on Router B.
[RouterB] display igmp proxy group
IGMP proxy group records in total: 1
GigabitEthernet2/1/1(192.168.1.2):
IGMP proxy group records in total: 1
Group address Member state Expires
224.1.1.1 Delay 00:00:02
Troubleshooting IGMP
No membership information on the receiver-side router
Symptom
When a host sends a report for joining the multicast group G, no membership information of the multicast
group G exists on the router closest to that host.
Analysis
• The correctness of networking and interface connections and whether the protocol layer of the
interface is up directly affect the generation of group membership information.
• Multicast routing must be enabled on the router. IGMP must be enabled on the interface that
connects to the host.
• If the IGMP version on the router interface is lower than that on the host, the router cannot recognize
the IGMP report from the host.
• If you have configured the igmp group-policy command on the interface, the interface cannot
receive report messages that failed to pass filtering.
Solution
1. Use the display igmp interface command to verify that the networking, interface connection, and
IP address configuration are correct. If the command does not produce output, the interface is in an
abnormal state. The reason might be that you have configured the shutdown command on the
interface, the interface is not correctly connected, or the IP address configuration is not correctly
completed.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP MSR2003 and is the answer not in the manual?

HP MSR2003 Specifications

General IconGeneral
BrandHP
ModelMSR2003
CategoryNetwork Router
LanguageEnglish

Related product manuals