EasyManuals Logo

HP MSR2003 User Manual

HP MSR2003
350 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
52
[RouterA-GigabitEthernet2/1/1] quit
[RouterA] interface gigabitethernet 2/1/2
[RouterA-GigabitEthernet2/1/2] pim dm
[RouterA-GigabitEthernet2/1/2] quit
# Enable IP multicast routing and PIM-DM on Router B in the same way Router A is configured.
(Details not shown.)
4. Display information about their RPF routes to Source 2 on Router B and Router C.
[RouterB] display multicast rpf-info 50.1.1.100
[RouterC] display multicast rpf-info 50.1.1.100
No output is displayed because no RPF routes to Source 2 exist on Router B and Router C.
5. Configure a static multicast route:
# Configure a static multicast route on Router B, specifying Router A as its RPF neighbor to Source
2.
[RouterB] ip rpf-route-static 50.1.1.100 24 30.1.1.2
# Configure a static multicast route on Router C, specifying Router B as its RPF neighbor to Source
2.
[RouterC] ip rpf-route-static 50.1.1.100 24 20.1.1.2
Verifying the configuration
# Display information about their RPF routes to Source 2 on Router B and Router C.
[RouterB] display multicast rpf-info 50.1.1.100
RPF information about source 50.1.1.100:
RPF interface: GigabitEthernet2/1/3, RPF neighbor: 30.1.1.2
Referenced route/mask: 50.1.1.0/24
Referenced route type: multicast static
Route selection rule: preference-preferred
Load splitting rule: disable
[RouterC] display multicast rpf-info 50.1.1.100
RPF information about source 50.1.1.100:
RPF interface: GigabitEthernet2/1/2, RPF neighbor: 20.1.1.2
Referenced route/mask: 50.1.1.0/24
Referenced route type: multicast static
Route selection rule: preference-preferred
Load splitting rule: disable
The output shows that the RPF routes to Source 2 exist on Router B and Router C. These RPF routes are the
configured static multicast routes.
Multicast forwarding over a GRE tunnel
Network requirements
As shown in Figure 21:
• Multicast routing and PIM-DM are enabled on Router A and Router C. Router B does not support
multicast.
• OSPF is running on Router A, Router B, and Router C.
Configure a GRE tunnel so that the receiver host can receive the multicast data from Source.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP MSR2003 and is the answer not in the manual?

HP MSR2003 Specifications

General IconGeneral
BrandHP
ModelMSR2003
CategoryNetwork Router
LanguageEnglish

Related product manuals