HP MSR2003 User Manual

232
Configuring an IPv6 multicast group filter on a port
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet interface
view.
interface interface-type
interface-number
N/A
3. Configure an IPv6 multicast
group filter for the port.
mld-snooping group-policy
acl6-number [ vlan vlan-list ]
By default, no IPv6 multicast group
filter is configured for the port. The
hosts on this port can join any valid
IPv6 multicast group.
Configuring IPv6 multicast source port filtering
This feature is supported on the following hardware:
MSR routers installed with the Layer 2 switching module HMIM 24GSW, HMIM 24GSW-POE, or HMIM
8GSW.
When the IPv6 multicast source port filtering feature is enabled on a port, the port blocks all multicast
data packets, but it permits IPv6 multicast protocol packets to pass. You can connect the port to only IPv6
multicast receivers rather than to multicast sources.
If this feature is disabled on the port, you can connect the port to either multicast sources or IPv6 multicast
receivers.
You can enable multicast source port filtering either for the specified ports in MLD-snooping view or for
the current port in interface view. These configurations have the same priority level.
Configuring IPv6 multicast source port filtering globally
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter MLD-snooping view.
mld-snooping N/A
3. Enable IPv6 multicast source
port filtering.
source-deny port interface-list
By default, the IPv6 multicast
source port filtering is disabled.
Configuring IPv6 multicast source port filtering on a port
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet interface
view.
interface interface-type
interface-number
N/A
3. Enable IPv6 multicast source
port filtering.
mld-snooping source-deny
By default, the IPv6 multicast
source port filtering is disabled.

HP MSR2003 Specifications

General

Brand	HP
Model	MSR2003
Category	Network Router
Language	English