HP MSR2003 User Manual

301
Configuring IPv6 BIDIR-PIM
This section describes how to configure IPv6 BIDIR-PIM.
IPv6 BIDIR-PIM configuration task list
Task at a
g
lance
(Required.) Enabling IPv6 BIDIR-PIM
(Required.) Configuring an RP:
• Configuring a static RP
• Configuring a C-RP
• Configuring the maximum number of IPv6 BIDIR-PIM RPs
NOTE:
You must configure a static RP, a C-RP, or both in an IPv6 BIDIR-PIM domain.
In an IPv6 network without C-RPs, skip the task of configuring a BSR.
Configuring a BSR
• (Required.) Configuring a C-BSR
• (Optional.) Configuring an IPv6 PIM domain border
• (Optional.) Disabling the BSM semantic fragmentation function
(Optional.) Configuring common IPv6 PIM features
(Optional.) Enabling SNMP notifications for IPv6 PIM
Configuration prerequisites
Before you configure IPv6 BIDIR-PIM, configure an IPv6 unicast routing protocol so that all devices in the
domain are interoperable at the network layer.
Enabling IPv6 BIDIR-PIM
Because IPv6 BIDIR-PIM is implemented on the basis of IPv6 PIM-SM, you must enable IPv6 PIM-SM
before enabling IPv6 BIDIR-PIM. When you deploy an IPv6 BIDIR-PIM domain, HP recommends that you
enable IPv6 PIM-SM on all non-border interfaces of the domain.
IMPORTANT:
A
ll interfaces on a device must be enabled with the same IPv6 PIM mode.
To enable IPv6 BIDIR-PIM:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IPv6 multicast
routing and enter MRIB
view.
ipv6 multicast routing [ vpn-instance
vpn-instance-name ]
By default, IPv6 multicast routing is
disabled.
3. Return to system view.
quit N/A

HP MSR2003 Specifications

General

Brand	HP
Model	MSR2003
Category	Network Router
Language	English