HP MSR2003 - SA Message Filtering Configuration

165
(*, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: WC
UpTime: 00:12:07
Upstream interface: Register
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet2/1/1
Protocol: igmp, UpTime: 00:12:07, Expires: -
(10.110.6.100, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: SPT 2MSDP ACT
UpTime: 00:40:22
Upstream interface: GigabitEthernet2/1/2
Upstream neighbor: 10.110.4.2
RPF prime neighbor: 10.110.4.2
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet2/1/1
Protocol: pim-sm, UpTime: - , Expires: -
The output shows that Router D now acts as the RP for Source 2 and Host B.
SA message filtering configuration
Network requirements
As shown in Figure 55, OSPF runs within and among the PIM-SM domains to provide unicast routing.
Set up an MSDP peering relationship between Router A and Router C and between Router C and Router
D.
Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30. Source 2 sends
multicast data to the multicast group 227.1.1.0/30.
Configure SA message filtering rules so that:
• Host A and Host B receive the multicast data only addressed to multicast groups 225.1.1.0/30 and
226 .1.1. 0 / 3 0 .
• Host C receives the multicast data only addressed to multicast groups 226.1.1.0/30 and
227.1.1.0 / 3 0 .