HP MSR2003 User Manual

306
NOTE:
Generally, a BSR performs BSM semantic fragmentation according to the MTU of its BSR interface. For
BSMs originated due to learning of a new IPv6 PIM neighbor, semantic fragmentation is performed
according to the MTU of the interface that sends the BSMs.
Configuring IPv6 PIM-SSM
IPv6 PIM-SSM requires MLDv2 support. Enable MLDv2 on IPv6 PIM routers that connect to multicast
receivers.
IPv6 PIM-SSM configuration task list
Task at a
g
lance
(Required.) Enabling IPv6 PIM-SM
(Optional.) Configuring the IPv6 SSM group range
(Optional.) Configuring common IPv6 PIM features
Configuration prerequisites
Before you configure IPv6 PIM-SSM, configure an IPv6 unicast IPv6 routing protocol so that all devices in
the domain are interoperable at the network layer.
Enabling IPv6 PIM-SM
The implementation of the IPv6 SSM model is based on subsets of IPv6 PIM-SM. Therefore, you must
enable IPv6 PIM-SM before configuring IPv6 PIM-SSM.
When you deploy an IPv6 PIM-SSM domain, enable IPv6 PIM-SM on non-border interfaces of the
routers.
IMPORTANT:
A
ll the interfaces on a device must be enabled with the same IPv6 PIM mode.
To enable IPv6 PIM-SM:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IP multicast routing,
and enter MRIB view.
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
By default, IPv6 multicast routing is
disabled.
3. Return to system view.
quit
N/A
4. Enter interface view.
interface interface-type
interface-number
N/A
5. Enable IPv6 PIM-SM.
ipv6 pim sm
By default, IPv6 PIM-SM is
disabled.

HP MSR2003 Specifications

General

Brand	HP
Model	MSR2003
Category	Network Router
Language	English