HP MSR2003 User Manual

185
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a VPN instance and
enter VPN instance view.
ip vpn-instance vpn-instance-name
By default, no VPN instance exists
on the device.
For more information about this
command, see MPLS Command
Reference.
3. Configure an RD for the VPN
instance.
route-distinguisher
route-distinguisher
By default, no RD is configured for
a VPN instance.
For more information about this
command, see MPLS Command
Reference.
4. Return to system view.
quit N/A
5. Enable IP multicast routing for
the VPN instance and enter
MRIB view of this VPN
instance.
multicast routing vpn-instance
vpn-instance-name
Disabled by default.
Creating the MD for a VPN instance
You can create one or multiple MDs to provide services for their associated VPN instances on the PE
device. When you create the MD for a VPN instance, the system automatically create the MTI interfaces
and bind them with the VPN instance.
To create the MD for a VPN instance:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create the MD for the VPN
instance and enter MD view.
multicast-domain vpn-instance
vpn-instance-name
By default, no MD exists for a VPN
instance.
Specifying the default-group address
The MTI uses the default-group address as the destination address to encapsulate the VPN multicast
packets.
For the MD of the same VPN instance on different PE devices, the default-group address must be the same
but different from the default-group address and the data-group address used by other MDs.
Perform the following task on the PE.
To specify the default-group:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MD view.
multicast-domain vpn-instance
vpn-instance-name
N/A

HP MSR2003 Specifications

General

Brand	HP
Model	MSR2003
Category	Network Router
Language	English