EasyManuals Logo

HP MSR2003 User Manual

HP MSR2003
350 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #234 background imageLoading...
Page #234 background image
224
To specify the MLD snooping version for a VLAN in VLAN view:
Ste
p
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter VLAN view.
vlan vlan-id N/A
3. Specify the version of MLD
snooping.
mld-snooping version
version-number
The default setting is MLDv1
snooping.
Setting the maximum number of MLD snooping forwarding
entries
You can modify the maximum number of MLD snooping forwarding entries. When the number of
forwarding entries on the device reaches the upper limit, the device does not automatically remove any
existing entries. To avoid the situation that new entries cannot be created, HP recommends that you
manually remove some entries.
To set the maximum number of MLD snooping forwarding entries:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter MLD-snooping view.
mld-snooping N/A
3. Set the maximum number of
MLD snooping forwarding
entries.
entry-limit limit
The default setting is
4294967295.
Configuring MLD snooping port functions
Before you configure MLD snooping port functions, complete the following tasks:
• Enable MLD snooping for the VLAN.
• Determine the aging timer for dynamic router ports.
• Determine the aging timer for dynamic member ports.
• Determine the addresses of the IPv6 multicast group and IPv6 multicast source.
Setting aging timers for dynamic ports
When you set aging timers for dynamic ports, follow these guidelines:
• If the memberships of IPv6 multicast groups frequently change, set a relatively small value for the
aging timer of the dynamic member ports. If the memberships of IPv6 multicast groups rarely
change, you can set a relatively large value.
• If a dynamic router port receives an IPv6 PIMv2 hello message, the aging timer for the port is
specified by the hello message. In this case, the mld-snooping router-aging-time command does
not take effect on the port.
• You can set the aging timers for dynamic ports either for the current VLAN in VLAN view or globally
for all VLANs in MLD-snooping view. If configurations are made in both VLAN view and
MLD-snooping view, the configuration made in VLAN view takes priority.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP MSR2003 and is the answer not in the manual?

HP MSR2003 Specifications

General IconGeneral
BrandHP
ModelMSR2003
CategoryNetwork Router
LanguageEnglish

Related product manuals