HP MSR2003 User Manual

229
To speed up the response of hosts to MLD queries and to avoid simultaneous timer expirations from
causing MLD report traffic bursts, you must correctly set the maximum response time.
• The maximum response time for MLD general queries is set by the max-response-time command.
• The maximum response time for MLD multicast-address-specific queries is the same as the MLD last
listener query interval, which is set by the last-listener-query-interval command.
You can configure parameters for MLD queries and responses either for the current VLAN in VLAN view
or globally for all VLANs in MLD-snooping view. If the configurations are made in both VLAN view and
MLD-snooping view, the configuration made in VLAN view takes priority.
Configuring parameters for MLD queries and responses globally
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MLD-snooping view.
mld-snooping N/A
3. Set the maximum response
time for MLD general queries.
max-response-time interval The default setting is 10 seconds.
4. Set the MLD last listener query
interval.
last-listener-query-interval interval
The default setting is 1 second.
Configuring parameters for MLD queries and responses in a VLAN
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VLAN view.
vlan vlan-id N/A
3. Set the maximum response
time for MLD general queries in
the VLAN.
mld-snooping max-response-time
interval
The default setting is 10 seconds.
4. Set the MLD last listener query
interval in the VLAN.
mld-snooping
last-listener-query-interval interval
The default setting is 1 second.
Configuring parameters for MLD messages
This section describes how to configure parameters for MLD messages.
Configuration prerequisites
Before you configure parameters for MLD messages, complete the following tasks:
• Enable MLD snooping for the VLAN.
• Determine the source IPv6 address of MLD general queries.
• Determine the source IPv6 address of MLD multicast-address-specific queries.
• Determine the source IPv6 address of MLD reports.
• Determine the source IPv6 address of MLD done messages.
• Determine the 802.1p precedence of MLD messages.

HP MSR2003 Specifications

General

Brand	HP
Model	MSR2003
Category	Network Router
Language	English