HP MSR2003

To Next Page

To Previous Page

195

# Assign an IP address to the public network interface GigabitEthernet 2/1/1, and enable

PIM-SM, MPLS capability, and LDP capability on the interface.

[PE2] interface gigabitethernet 2/1/1

[PE2-GigabitEthernet2/1/1] ip address 192.168.7.1 24

[PE2-GigabitEthernet2/1/1] pim sm

[PE2-GigabitEthernet2/1/1] mpls enable

[PE2-GigabitEthernet2/1/1] mpls ldp enable

[PE2-GigabitEthernet2/1/1] quit

# Bind GigabitEthernet 2/1/2 with VPN instance b, assign an IP address to GigabitEthernet

2/1/2, and enable PIM-SM on the interface.

[PE2] interface gigabitethernet 2/1/2

[PE2-GigabitEthernet2/1/2] ip binding vpn-instance b

[PE2-GigabitEthernet2/1/2] ip address 10.110.3.1 24

[PE2-GigabitEthernet2/1/2] pim sm

[PE2-GigabitEthernet2/1/2] quit

# Bind GigabitEthernet 2/1/3 with VPN instance a, assign an IP address to GigabitEthernet

2/1/3, and enable PIM-SM on the interface.

[PE2] interface gigabitethernet 2/1/3

[PE2-GigabitEthernet2/1/3] ip binding vpn-instance a

[PE2-GigabitEthernet2/1/3] ip address 10.110.4.1 24

[PE2-GigabitEthernet2/1/3] pim sm

[PE2-GigabitEthernet2/1/3] quit

# Assign an IP address to Loopback 1, and enable PIM-SM on this interface.

[PE2] interface loopback 1

[PE2-LoopBack1] ip address 1.1.1.2 32

[PE2-LoopBack1] pim sm

[PE2-LoopBack1] quit

# Configure BGP.

[PE2] bgp 100

[PE2-bgp] group vpn-g internal

[PE2-bgp] peer vpn-g connect-interface loopback 1

[PE2-bgp] peer 1.1.1.1 group vpn-g

[PE2-bgp] peer 1.1.1.3 group vpn-g

[PE2–bgp] ip vpn-instance a

[PE2-bgp-a] address-family ipv4

[PE2-bgp-ipv4-a] import-route rip 2

[PE2-bgp-ipv4-a] import-route direct

[PE2-bgp-ipv4-a] quit

[PE2-bgp-a] quit

[PE2–bgp] ip vpn-instance b

[PE2-bgp-b] address-family ipv4

[PE2-bgp-ipv4-b] import-route rip 3

[PE2-bgp-ipv4-b] import-route direct

[PE2-bgp-ipv4-b] quit

[PE2-bgp-b] quit

[PE2–bgp] address-family vpnv4

[PE2–bgp-vpnv4] peer vpn-g enable

[PE2–bgp-vpnv4] quit

Table of Contents

Related product manuals