240
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign GigabitEthernet 2/1/1 through GigabitEthernet 2/1/3 to the VLAN,
and enable MLD snooping for the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port gigabitethernet 2/1/1 to gigabitethernet 2/1/3
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] quit
# Configure GigabitEthernet 2/1/3 as a static router port.
[SwitchA] interface gigabitethernet 2/1/3
[SwitchA-GigabitEthernet2/1/3] mld-snooping static-router-port vlan 100
[SwitchA-GigabitEthernet2/1/3] quit
4. Configure Switch B:
# Enable MLD snooping globally.
<SwitchB> system-view
[SwitchB] mld-snooping
[SwitchB-mld-snooping] quit
# Create VLAN 100, assign GigabitEthernet 2/1/1 and GigabitEthernet 2/1/2 to the VLAN,
and enable MLD snooping for the VLAN.
[SwitchB] vlan 100
[SwitchB-vlan100] port gigabitethernet 2/1/1 gigabitethernet 2/1/2
[SwitchB-vlan100] mld-snooping enable
[SwitchB-vlan100] quit
5. Configure Switch C:
# Enable MLD snooping globally.
<SwitchC> system-view
[SwitchC] mld-snooping
[SwitchC-mld-snooping] quit
# Create VLAN 100, assign GigabitEthernet 2/1/1 through GigabitEthernet 2/1/5 to the VLAN,
and enable MLD snooping for the VLAN.
[SwitchC] vlan 100
[SwitchC-vlan100] port gigabitethernet 2/1/1 to gigabitethernet 2/1/5
[SwitchC-vlan100] mld-snooping enable
[SwitchC-vlan100] quit
# Configure GigabitEthernet 2/1/3 and GigabitEthernet 2/1/5 as static member ports for the
IPv6 multicast group FF1E::101.
[SwitchC] interface gigabitEthernet 2/1/3
[SwitchC-GigabitEthernet2/1/3] mld-snooping static-group ff1e::101 vlan 100
[SwitchC-GigabitEthernet2/1/3] quit
[SwitchC] interface gigabitEthernet 2/1/5
[SwitchC-GigabitEthernet2/1/5] mld-snooping static-group ff1e::101 vlan 100
[SwitchC-GigabitEthernet2/1/5] quit
Verifying the configuration
# Display information about the static router ports in VLAN 100 on Switch A.
[SwitchA] display mld-snooping static-router-port vlan 100
VLAN 100:
Router slots (0 in total):
To Next Page
Loading...
