35
[SwitchA-vlan100] quit
# Configure GigabitEthernet 2/1/3 as a static router port.
[SwitchA] interface gigabitethernet 2/1/3
[SwitchA-GigabitEthernet2/1/3] igmp-snooping static-router-port vlan 100
[SwitchA-GigabitEthernet2/1/3] quit
4. Configure Switch B:
# Enable IGMP snooping globally.
<SwitchB> system-view
[SwitchB] igmp-snooping
[SwitchB-igmp-snooping] quit
# Create VLAN 100, assign GigabitEthernet 2/1/1 and GigabitEthernet 2/1/2 to the VLAN,
and enable IGMP snooping for the VLAN.
[SwitchB] vlan 100
[SwitchB-vlan100] port gigabitethernet 2/1/1 gigabitethernet 2/1/2
[SwitchB-vlan100] igmp-snooping enable
[SwitchB-vlan100] quit
5. Configure Switch C:
# Enable IGMP snooping globally.
<SwitchC> system-view
[SwitchC] igmp-snooping
[SwitchC-igmp-snooping] quit
# Create VLAN 100, assign GigabitEthernet 2/1/1 through GigabitEthernet 2/1/5 to the VLAN,
and enable IGMP snooping for the VLAN.
[SwitchC] vlan 100
[SwitchC-vlan100] port gigabitethernet 2/1/1 to gigabitethernet 2/1/5
[SwitchC-vlan100] igmp-snooping enable
[SwitchC-vlan100] quit
# Configure GigabitEthernet 2/1/3 and GigabitEthernet 2/1/5 as static member ports for
multicast group 224.1.1.1.
[SwitchC] interface gigabitEthernet 2/1/3
[SwitchC-GigabitEthernet2/1/3] igmp-snooping static-group 224.1.1.1 vlan 100
[SwitchC-GigabitEthernet2/1/3] quit
[SwitchC] interface gigabitEthernet 2/1/5
[SwitchC-GigabitEthernet2/1/5] igmp-snooping static-group 224.1.1.1 vlan 100
[SwitchC-GigabitEthernet2/1/5] quit
Verifying the configuration
# Display information about the static router ports in VLAN 100 on Switch A.
[SwitchA] display igmp-snooping static-router-port vlan 100
VLAN 100:
Router slots (0 in total):
Router ports (1 in total):
GE2/1/3
The output shows that GigabitEthernet 2/1/3 on Switch A has become a static router port.
# Display information about the static IGMP snooping forwarding entries in VLAN 100 on Switch C.
[SwitchC] display igmp-snooping static-group vlan 100
To Next Page
Loading...
Need help?
General
