Huawei iSitePower-M MAP05A1 - Installing Internal Cables

Figure 10-1 Installing a PE cable
----End
10.1.2 Installing Internal Cables
CA UTION
● Do not reversely connect positive and negative battery module power cables.
● Use the power cables delivered with the product. If the number of cables is
insucient or any cable is damaged, contact the vendor to obtain cables. Do
not prepare cables by yourself.
NO TICE
When a communications terminal is connected to a single network cable, a
waterproof rubber plug must be installed.
Procedure
Step 1 Install a PE cable.
iSitePower-M (MAP05A1, MAB05B1)
User Manual 10 Electrical Connections
Issue 06 (2023-04-24) Copyright © Huawei Digital Power Technologies Co., Ltd. 100