Huawei iSitePower-M MAP05A1 - Installing an AC Output Power Cable

Figure 10-12 Installing battery signal cables
NO TICE
When a communications terminal is connected to a single network cable, the
waterproof rubber plug must be installed for the hole with no cable routed.
Otherwise, the waterproof performance may be
aected and the device will be
damaged.
----End
10.2.3 Installing an AC Output Power Cable
CA UTION
● The live (L) wire and neutral (N) wire of an AC power cable must be correctly
connected.
● The PE wire of an AC power cable must be grounded.
● Do not reversely connect AC output power cables.
iSitePower-M (MAP05A1, MAB05B1)
User Manual 10 Electrical Connections
Issue 06 (2023-04-24) Copyright © Huawei Digital Power Technologies Co., Ltd. 109