Huawei iSitePower-M MAP05A1 - Installing PV Input Power Cables

Figure 10-4 Installing battery signal cables
NO TICE
When a communications terminal is connected to a single network cable, the
waterproof rubber plug must be installed for the hole with no cable routed.
Otherwise, the waterproof performance may be
aected and the device will be
damaged.
----End
10.1.3 Installing PV Input Power Cables
Step 1 Use a removal wrench to remove the waterproof gland from the PV input terminal
on the power module.
NO TE
Take out the removal wrench from the decorative cover delivered with the product.
Step 2 Install the PV input power cables.
iSitePower-M (MAP05A1, MAB05B1)
User Manual 10 Electrical Connections
Issue 06 (2023-04-24) Copyright © Huawei Digital Power Technologies Co., Ltd. 103