Huawei iSitePower-M MAP05A1 - B Preparing Cables and Terminals; Preparing a Cord End Terminal; Preparing an OT Terminal

B Preparing Cables and Terminals
B.1 Preparing a Cord End Terminal
Figure B-1 Preparing a cord end terminal
(1) Cable
(2) Cord end terminal (3) Crimping tool
B.2 Preparing an OT Terminal
NO TICE
● Avoid scratching the core wire when stripping a cable.
● The cavity formed after the conductor crimp strip of the OT terminal is crimped
must wrap the core wires completely. The core wires must contact the OT
terminal closely.
● Wrap the wire crimping area with heat shrink tubing or insulation tape. The
heat shrink tubing is used as an example.
● When using a heat gun, protect the equipment from being scorched.
iSitePower-M (MAP05A1, MAB05B1)
User Manual B Preparing Cables and Terminals
Issue 06 (2023-04-24) Copyright © Huawei Digital Power Technologies Co., Ltd. 207