13.4 Removing Power Terminals
There are three methods of using the cable removal tool. Select a proper method
based on the actual situation.
Figure 13-1 Usage of the removal tool
(1) Battery module input port (2) Battery cascading port (3) PV input port
13.5 Power-On
Do not touch the manual ON/OFF switch during the installation. Otherwise,
electric shocks may occur.
13.6 SOC Changes
How does the charging mode changes when the SOC is turning from 99% to
100%?
When the SOC is greater than 99%, the battery switches to
oat charging mode
and the charge current decreases gradually until the SOC reaches 100%.
13.7 Checking Cable Connections When the Product
Fails to Be Upgraded
If the product fails to be upgraded, check the cable connections. Ensure that the
cables are correctly connected and perform the upgrade again.
13.8 WiFi QR Code Scanning
Scan the QR code on the device to connect to the WiFi. If the connection fails,
contact your installer.
13.9 Querying the Battery Capacity in Parallel-System
Scenarios
Query the total system capacity on the app.
iSitePower-M (MAP05A1, MAB05B1)
User Manual 13 FAQs
Issue 06 (2023-04-24) Copyright © Huawei Digital Power Technologies Co., Ltd. 200
To Next Page
Loading...
