Huawei iSitePower-M MAP05A1 - Installing Genset Control Cables

Figure 10-58 Installing an AC input power cable
----End
10.6.6 Installing Genset Control Cables
NO TICE
For a genset that starts when the dry contact is open, connect the signal cable to
ports NC and COM. For a genset that starts when the dry contact is closed,
connect the signal cable to ports NO and COM.
Procedure
Step 1 Install genset control signal cables.
iSitePower-M (MAP05A1, MAB05B1)
User Manual 10 Electrical Connections
Issue 06 (2023-04-24) Copyright © Huawei Digital Power Technologies Co., Ltd. 146