● You can modify the contents of the template. Do not change settings of
centered characters, direction, and fonts.
● If many characters need to be lled in, decrease the font size, but make sure
that the printouts are clear and legible.
Merging Cells in the Template
To merge two or more cells, do as follows:
1. Select Edit/Select All.
2. Select Format/Borders and Shading/Borders. Select Box tab and click OK.
3. Drag the mouse to select cells to be merged and select the Table/Merge
Cells.
Requirements on the Printer
To print labels, use a laser jet printer of any model. Before printing labels, set up
the page and try printing.
1. Try printing on ordinary paper with both sides blank. Place the blank paper
over the whole page of the label paper, and check whether the page setup
conforms to the label layout.
2. Make sure the printer properties, such as "paper size" and "direction", have
been set correctly.
– If the printout conforms to the sheet of labels, print the labels on the
label paper.
– If the printout does not conform, adjust the page setup and try printing
again until the correct printout is produced.
The method for adjusting the page setup is as follows.
1. Select File/Page Setup.
2. Select Layout and set Header and Footer as 0.
3. Select the Margins tab page. Select Left for Gutter Position and adjust the
values of Top, Bottom, Left, and Right.
If the warning prompt as shown in Figure 4-378 appears before printing, click Ignore
to continue the printing.
Figure 4-378 Warning prompt before printing
After the page setup has been made correctly, save it for future use. This page
setup is only necessary the rst time you use the template to print the labels.
HUAWEI NetEngine 8000 F
Hardware Guide 4 Hardware Installation and Parts Replacement
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 705
To Next Page
Loading...
Need help?
General
