Requirements for Feeding the Printer
The label paper consists of two layers and has undergone multiple processing
procedures such as printing and cutting. No matter what model of printer you use,
feed in the labels one page at a time. To avoid jamming the labels, never use the
auto-feed mode.
Feed in the label paper in the correct direction to ensure that the text is printed in
a correct position.
Requirements for the Printed Label
Make sure that the printed labels satisfy the following requirements:
● All the printouts must be on the label, and nothing should be printed on the
backing layer of the label page.
● Contents in the cells should be aligned in the center. In a single-line printout,
the dividing lines and the word "TO:" should not be covered by printed
characters.
● When the cells are merged and the printouts are made in multiple lines, avoid
covering the word "TO:" when printing the text. Use the space bar to move
the text to the next line.
Writing Labels
Writing Tools
To make sure the printouts are clear and legible, use black markers instead of
ball-point pens to write the labels.
If no marker is available, black ball-point pens are allowed, although not
recommended. Compared with ball-point pens, waterproof markers are better.
When writing with a ball-point pen, do not leave the oil on the label, which may
contaminate the label and blur the words.
The delivered marker has two nibs. Use the smaller nib to write the labels.
Font
For the sake of legibility, use standard block letters and numbers as shown in
Table 4-83.
Table 4-83 Standard typeface for handwriting
0
1 2 3 4 5 6 7 8
9 A B C D E F G H
I J K L M N O P Q
R S T U V W X Y Z
HUAWEI NetEngine 8000 F
Hardware Guide 4 Hardware Installation and Parts Replacement
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 706
To Next Page
Loading...
Need help?
General
