Operation Manual – Stack&Cluster
Quidway S3100 Series Ethernet Switches Chapter 2
Cluste
Huawei Technologies Proprietary
2-13
[Quidway] ndp enable
[Quidway] interface ethernet 1/0/2
[Quidway-Ethernet1/0/2] ndp enable
[Quidway-Ethernet1/0/2] interface ethernet 1/0/3
[Quidway-Ethernet1/0/3] ndp enable
# Configure the holdtime of NDP information to be 200 seconds.
[Quidway] ndp timer aging 200
# Configure the interval to send NDP packets to be 70 seconds.
[Quidway] ndp timer hello 70
# Enable NTDP globally and for Ethernet1/0/2 and Ethernet1/0/3 ports.
[Quidway] ntdp enable
[Quidway] interface ethernet 1/0/2
[Quidway-Ethernet1/0/2] ntdp enable
[Quidway-Ethernet1/0/2] interface ethernet 1/0/3
[Quidway-Ethernet1/0/3] ntdp enable
# Configure the hop count to collect topology to be 2.
[Quidway] ntdp hop 2
# Configure the delay time for topology-collection request packets to be forwarded on
member devices to be 150 ms.
[Quidway] ntdp timer hop-delay 150
# Configure the delay time for topology-collection request packets to be forwarded
through the ports of member devices to be 15 ms.
[Quidway] ntdp timer port-delay 15
# Configure the interval to collect topology information to be 3 minutes.
[Quidway] ntdp timer 3
# Enable the cluster function.
[Quidway] cluster enable
# Enter cluster view.
[Quidway] cluster
[Quidway-cluster]
# Configure an IP address pool for the cluster. The IP address pool contains eight IP
addresses, starting from 172.16.0.1.
[Quidway-cluster] ip-pool 172.16.0.1 255.255.255.248
# Specify a name for the cluster and create the cluster.
[Quidway-cluster] build huawei
[huawei_0. Quidway-cluster]
# Add the attached two switches to the cluster.
To Next Page
Loading...
Need help?
General