Operation Manual – System Maintenance and Debugging
Quidway S3100 Series Ethernet Switches Chapter 1
BootROM and Host Software Loading
Huawei Technologies Proprietary
1-7
Figure 1-5 Sending file page
After the download completes, the system displays the following information:
Loading ...CCCCCCCCCC done!
Note:
You need not reset the HyperTerminal’s baud rate and can skip the last step if you have
chosen 9600 bps. In this case, the system display the prompt “BootROM is updating
now.....................................done!” instead of the prompt "Your baudrate should be set
to 9600 bps again! Press enter key when ready".
Step 9: Reset HyperTerminal’s baud rate to 9600 bps (refer to Step 4 and 5). Then,
press any key as prompted. The system will display the following information when it
completes the loading.
Bootrom updating.....................................done!
III. Loading host software
Follow these steps to load the host software:
Step 1: Select <1> in Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
To Next Page
Loading...
