Huawei S1700 Series - Ipv4 Static;Default Route Configure

S1700 Managed Series Ethernet Switches
Web User Manual
8 IP Routing
Issue 05 (2012-10-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
116
Item
Description
Interface
VLAN number of static routing entry
Protocol Type
Routing Type
8.1.2 IPv4 Static/Default Route Configure
Click Routing >IPv4 Route >IPv4 Static/Default Route configure; the configuration page is
shown as the figure below.
Figure 8-2 IPv4 Routing
Table 8-2 Parameters of Configuring IPv4 Routing
Item
Description
IP Address/Mask
The IP address/mask of destination network segment of routing
Gateway
Gateway IP address (The address of next hop)
Protocol Type
Routing type.
Backup State
Primary or secondary routing
Status
The routing is effective or not, which means it can be used to
conduct routing forwarding or not.
Create a Ipv4 Routing
Step 1 Click IP Routing>IPv4 Route > IPv4 Static/Default Route Configure.
Step 2 Click New button, opening the configuration page shown as the figure below.
Figure 8-3 New IPv4 Routing