Huawei S1700 Series - RADIUS Server Settings

S1700 Managed Series Ethernet Switches
Web User Manual
9 Security
Issue 05 (2012-10-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
170
9.14.2 RADIUS Server Settings
Click Security > RADIUS > RADIUS Server Settings to check the RADIUS server on switch,
the configuration page is displayed as follows.
Figure 9-59 RADIUS Server Settings
Table 9-40 Parameters of RADIUS Server Settings
Item
Description
IP Address
RADIUS authentication server address.
Auth-port
Set the UDP port on RADIUS authentication server. Values range from
1 to 65535. Default is 1812.
Acct-port
Set the UDP port on RADIUS account server. Values range from 1 to
65535. Default is 1813.
Retransmit
This value is the number of requests sent by switch when there is no
response in authentication server. If setting the sever parameter as
Re-sent, switch will take the re-sent parameters in global configuration
as server default configuration. Values range from 1 to 5.
Timeout
Enter the time (in seconds) for which. The switch will wait the server
host to response certificate request. If setting the sever parameter as
Time-out, switch will take the re-sent parameters in global configuration
as server default configuration. Values range from 3 to 10 seconds.
Key
Enter the key on RADIUS server. Values range from 1 to 16.
Confirm key
Re-enter the key on the RADIUS server. Values range from 1 to 16.
Add RADIUS sever
Step 1 Click Security > RADIUS.
Step 2 Click RADIUS Server Settings in Tab.
Step 3 Set the parameters in RADIUS-server Authentication Settings section.
Step 4 Click Apply button to add RADIUS sever. The successful configured RADIUS sever will be
displayed in sever list.
----End