Huawei S1700 Series - Stp; STP Information

S1700 Managed Series Ethernet Switches
Web User Manual
5 Service Management
Issue 05 (2012-10-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
55
Click Service Management > MAC > Migrate MAC Table page to open the page as shown in
following figure, which displays the information of all the MAC address migration
Figure 5-25 Migrate MAC Table
Table 5-14 Parameters of Migrate MAC Table
Item
Description
MAC Address
MAC address in address table.
VLAN ID
VLAN ID that corresponds to the above MAC address
Old Interface Name
The interface number from which the MAC address
migrates.
New Interface Name
The interface number to which the MAC address
migrates.
5.5 STP
Spanning Tree Protocol (STP) is used to decrease link failure in network and provides
protection for network by preventing loop circuit. It is easy to generate unconscious loop
broadcast storm in complex network construction. It is disabled by default. To enable this
function, you must enable STP/RSTP/MSTP function on each switch connected to network.
The switch supports three versions of Spanning Tree Protocol: STP, RSTP and MSTP.
5.5.1 STP Information
Click Service Management > STP > STP Information page to view the STP instance
information on the switch, as shown in the following figure