Huawei S1700 Series - One-Way Isolation

S1700 Managed Series Ethernet Switches
Web User Manual
9 Security
Issue 05 (2012-10-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
163
Figure 9-52 Set the parameters of Two-way Isolation
Step 4 Enable the Two-way Isolation function in Status field.
Step 5 Click Apply button to apply all the changes made.
----End
9.12.2 One-way Isolation
Click Security > Interface Isolation > One-way Isolation, the configuration page is displayed
as follows.
Figure 9-53 One-way Isolation
Table 9-35 Parameters of One-way Isolation
Item
Description
Query
Search the one-way Isolation settings of specified interface in
Interface Name.
Interface Name
Interface number
Isolated Interface List
Isolated or not isolated target interface. Deny or allow the specified
interface to send data packets to the target interface.
Set the parameters of One-way Isolation for interface
Step 1 Click Security > Interface Isolation.
Step 2 Click One-way Isolation in Tab.
Step 3 Click the check box of the One-way Isolation parameter on left side, and then click Configure
button to display the following page: