Huawei S1700 Series - Dot3 Tlvs

S1700 Managed Series Ethernet Switches
Web User Manual
10 Network
Issue 05 (2012-10-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
199
Step 5 Click Apply button to apply all the changes made.
----End
10.3.6 Dot3 TLVs
Click Network > LLDP > Dot3 TLVs to configure IEEE802.3 information of advertisement
TLV, the configuration page is displayed as follows.
Figure 10-32 Dot3 TLVs
Table 10-18 Parameters of Dot3 TLVs
Item
Description
Query
Search the Dot3 TLVs settings of specified interface in
Interface Name.
Interface Name
Interface number
MAC / PHY Configuration
Status
Whether to publish the MAC / PHY configuration status of
interface. MAC / PHY configuration status is the speed and
duplex state that supported by interfaces, whether to support
the interface speed auto-negotiation, whether to enable
auto-negotiation and the current speed and duplex status.
POE
Whether to publish the interface POE. POE refers to the
power supply through interface.
Link Aggregation
Whether to publish the link aggregation interface. Link
Aggregation refers to the interface whether to support link
aggregation and whether to enable the link aggregation.
Total Max Frames
Whether to publish the maximum frame length. Maximum
frame length is the maximum frame size supported by the
interface, and taken by the interface configuration MTU (Max
Transmission Unit).
Configure parameters of Dot3 TLVs for interface
Step 1 Click Network > LLDP.
Step 2 Click Dot3 TLVs in tab.