Huawei S1700 Series - Page 29

S1700 Managed Series Ethernet Switches
Web User Manual
3 System Management
S1700 Managed Serie s Etherne t Switches
Issue 05 (2012-10-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
19
IPv4 Address Settings (DHCP)
Step 1 Click System Management > IP Management > IPv4 to display the page as shown in Figure
3-8.
Step 2 Click the Edit icon in the right-hand column of Default item, the configuration page is shown
as follows.
Figure 3-9 IPv4 Address Settings
Table 3-9 Parameters of IPv4 Address Settings
Item
Description
Management mode
There are two ways to obtain IP address: manual configuration and
DHCP (Default: manual configuration)
VLAN ID
Select management VLAN ID from the drop-down menu.
Status
Choose to enable/disable this management interface.
IP Address
The fixed IP management address that user can manually configure
when IP address method is selected “manual”. Valid IP addresses
consist of four numbers, 0 to 255, separated by periods. (Default:
192.168.1.253)
Subnet Mask
This mask confirms the host address bits used for routing to
specific subnets. (Default: 255.255.255.0).
Secondary
The secondary IP address of the switch.
Step 3 Specified management mode is DHCP.
Step 4 Click Apply to apply all the changes made.
----End