S1700 Managed Series Ethernet Switches
Web User Manual
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-27 STP Global Settings
Table 5-16 Parameters of STP Global Settings
Enable or disable STP on this switch(default: disable)
Select instance number for the root types needed to
configure.
The options for root type: Not set, Primary and Secondary.
Select instance number for priority value needed to
configure.
Bridge priority is used in selecting the root device. The
device with the highest priority (the smaller value the
higher priority) becomes the STP root device. However, if
all devices have the same priority, the device with the
lowest MAC address will then become the root device
(note that lower numeric values indicate higher
priority) .Default value: 32768; Range: 0~61440; Step
Length: 4096.
To Next Page
Loading...
